- Up to 5k psi (350 bar)
- 5-12 gpm (20-45 l/min)
- For 3-6" Lines (51-102mm)
- High-Speed Technology
Powerful Tools Demand Respect
If this WARTHOG is being used in pipes larger than 4” in diameter, a rigid stinger should be installed between the tool inlet and the hose end. Otherwise the tool can turn around inside the line (as shown at below) and come back toward the operator, causing serious injury or death.
Stinger not in use here. Tool is backing out of the pipe.
Our smaller WARTHOG models have all the powerful features of the larger tools but can negotiate elbows and clean-outs commonly found in laterals at homes, buildings restaurants and other light commercial facilities. The WT-3/8-C is designed specifically to handle 3”-6” lines and clean-outs. This tool is most commonly used on small capacity pumps and cart jetters. We’ve added permanent carbide buttons to the WT-3/8-C model, specifically designed to handle demanding applications.
Pipes made of cast iron and those that have sand or silt can act as abrasive agents that can aggressively wear out the tool. Our carbide buttons are available in all offsets and add up to 5 times the life compared to previous models. It also features replaceable AP2 nozzles.
|Maximum Pressure||5k psi (350 bar)|
|Operating Pressure||2k – 5k psi (100-350 bar)|
|Rotation Speed||300-500 rpm|
|Flow||5-12 gpm (20-45 l/min)|
|Flow Rating||0.75 Cv|
|Pulling Force||5-20 lb (22-90 N)|
|Inlet Connection||3/8 NPT or BSPP|
|Tool Diameter||1.9 in. (48 mm)|
|Length||3.0 in. (76 mm)|
|Nozzle Ports||3 x 1/8 NPT|
|Weight Complete||1.2 lb (.54 kg)|