Warthog® WV-1/4″™
- Up to 4k psi (275 bar)
- 3-8 gpm Flows (11-30 l/min)
- 2”- 4” Lines (51-102 mm)
- New High-Speed Technology
Clean 2″- 4″ Lines with Elbows
The WV-1/4™ uses the new flow-through technology and features a revolutionary high-speed design with no high pressure seals or bearings to service. It cleans lines as small as 2” with long sweeping elbows. This new design also features permanent, pre-drilled orifices.
The tool operates from 2k-4k psi (100-275 bar) and 3-8 gpm (11-30 l/min). It has a 1/4” NPT pipe thread inlet and if a 1/4” NPT hose fitting is used the tool can pass through long radius elbows in 2” and larger lines.
There are no maintenance or overhaul kits due to the low maintenance design.
Please contact us, for more information regarding hose requirements.
Safety First!
Powerful Tools Demand Respect
If the WARTHOG WV-1/4″ is being used in pipes larger than 4” in diameter, a rigid stinger should be installed between the tool inlet and the hose end. Otherwise the tool can turn around inside the line (as shown at below) and come back toward the operator, causing serious injury or death.
Stinger not in use here. Tool is backing out of the pipe.
| Maximum Pressure | 4k psi (275 bar) |
| Operating Pressure | 2k – 4k psi (100-275 bar) |
| Rotation Speed | High Speed |
| Flow | 3-8 gpm (11.4-30.3 lpm) |
| Flow Rating | 0.8 Cv |
| Pulling Force | 9 lbs (40 N) |
| Inlet Port | 1/4 NPT or BSPP |
| Tool Diameter | 1.3 in. (33 mm) |
| Length | 2.0 in. (51 mm) |
| Ports | 3 Drilled |
| Weight Complete | 0.45 lb (.20 kg) |